LL LTM100

LTM-100

High-Resolution
Magnetostrictive
Level Transmitter

General Specifications

The Babbitt LTM series Magnetostrictive Level Transmitter is an accurate, stand-alone, loop-powered device, usually mounted in the top of a tank or other container. It may also be used as a level transmitter when mounted externally on a Babbitt Magnetic Level Gauge.

The unit is suitable for liquid applications that require high accuracy and repeatability. The unit may be ordered in several configurations that will give outputs of simple level, level and temperature, or two levels as in an interface application.

The Primary 4-20ma output is used for Level and optional HART protocol communications. The Secondary 4-20mA output may be used for Level or optional Temperature.

Dimensions

Calibration

The unit may be calibrated on the bench or in the tank where it will be used. Simply locate the float where you want the "Zero", press a button, then move the float to the "Span position and press another button. It's that fast and simple!

The memory is non-volitile, so the unit stays calibrated even during loss of power.

Theory of Operation

The sensor consists of a 5/8" stainless steel tube with a heat-treated wire stretched through the center of it. A magnetic float is placed around the tube and tracks the fluid level.

A low power microprocessor-controlled cicuit produces a high current pulse which is transmitted down the heat-treated wire. The magnetic field in the float interferes with the high current pulse creating a torsional wave which is "bounced" back to the electronics. The transit time of the wave is converted to a 4-20mA signal, proportional to the fluid level.

LTM-100 Specifications
Sensor Assembly:
Measuring Length	18" to 30 ft standard*.
Operating Temp.	-40 to +300 Deg F (high-temp option available)
Maximum Pressure	900psig @ 300 Deg F
Material	As Specified by Customer. 316SS, 304SS, Hastelloy, Kynar or specials. optional.
Mounting	3/4" MNPT compression fitting standard. Other sizes available. 2" min. nozzle size is required for float. Flanges available in all sizes and materials. available)
* A stilling well is recomended for lengths over 10ft or when in turbulent applications.

Electronics:

Analog Output	0.025% of full scale
Sensor Accuracy	Greater of 0.01% of full scale or 0.030"
Repeatability	Greater of 0.005% of full scale or 0.015"
Non-linearity	Greater of 0.01% of full scale or 0.030"
Output	Dual 4-20mA (2-wire) with HART protocol. Primary Output: Level and HART. Secondary Output: Level or Temp.
Damping	Field adjustable, 1 to 15 seconds.
Power	15-36VDC
Operating Temp.	-40 deg F to +150 deg F
Housing	Cast aluminum, epoxy coated.

Approvals FM CSA:

Class I, Div. 1, Groups B, C & D
Class II, Div. 1 & 2, Groups E, F & G
Class III

Specifications are subject to change without notice.

LTM-100S Ordering Information